TEC Peltier
http://tecpeltier.com/

Just stopped in to say Hi
http://tecpeltier.com/viewtopic.php?f=14&t=116
Page 1 of 1

Author:  bongo [ Sat May 19, 2012 2:20 am ]
Post subject:  Just stopped in to say Hi

Ultrasonic - I have Been following your post for a long time and just wanted to say thank you for the great information. Just when I start to get a handle on Tec's you would provide new information and I have to rethink everything. It has been a pleasure to read and follow your posts on tec's and your adventures in manufacturing and design.

Unfortunatly about all I can do now is read, two little ones keep me too busy to do anything else.

Keep up the posts, there are a lot of people who value your insight and knowledge.

Regards

Author:  Ultrasonic2 [ Sat May 19, 2012 9:03 am ]
Post subject:  Re: Just stopped in to say Hi

Thanks .
it's good to know people actually read this stuff and value it. A thanks goes a long way with me cos i've put so much time into it all.

I have more content that needs to go up on this site, but since no one seemed to care i haven't gotten round to it yet.

Thanks for the thanks

Author:  bongo [ Sat May 19, 2012 9:28 am ]
Post subject:  Re: Just stopped in to say Hi

I have followed you on many forums, enjoyed your post on setting up your cnc. I really enjoyed your block design and testing articles. Been coming here for awhile just lurking and reading, trying to understand tecs.

Page 1 of 1 All times are UTC + 12 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/