TEC Peltier
http://tecpeltier.com/

Negative outcomes of installing TECs with too much power?
http://tecpeltier.com/viewtopic.php?f=4&t=6125
Page 1 of 1

Author:  JK_TEC [ Wed Aug 02, 2017 12:36 am ]
Post subject:  Negative outcomes of installing TECs with too much power?

Hey there,

I am currently working on my first TEC project. The calculated cooling power to keep a circulating fluid at 4°C is about 67 watts (at normal room temperature). Unfortunately, there a quite many uncertanties which might increase the cooling power I need. For this reason, I would like to include a margin of safety by installing about twice the calculated cooling power (130 watts). I didn´t quite finish my calculations for TEC elements I need to install, but consider it around a Qc max of 600 watts. These elements should consume about half Vmax and Imax.


Here comes my question:
Lets say my initial calculations were correct and no more than about 67 watts of cooling power are needed to keep the fluid at 4°C. Will my TEC buildup do the job by running at a lower voltage/current than half Vmax/Imax?

I want to make sure that my buildup has enough power in the first try. This is a university project and adding more cooling power after a first expiriment with too little cooling power installed just looks bad ;)

Thanks a lot for your help in advance!

Author:  Ultrasonic2 [ Thu Aug 31, 2017 9:27 am ]
Post subject:  Re: Negative outcomes of installing TECs with too much power

hello unfortunately your question isn't clear enough to answer ?

Page 1 of 1 All times are UTC + 12 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/